|
|
|
|
|
| Two phases stepping driver |
|
|
|
|
| Name: |
2D34MG |
| Features |
| 2D34MG is a constant torque driver with microstep, voltage range from DC12-48V.single power input. It can match which rated current under 3.0A flange size range from 42-57mm.
Owe to bipolar constant current chopping circuit, the motor can run smoothly and hardly has any noise Rising the voltage can greatly improve high speed performance and output torque of the motor. Once the pulse stops for 100ms the phase current will automatically cut by half, which can reduce chances of overheat. Users can operate the driver with microstep in low speed occasion. The upmost microstep can be set to 64 x. |
|
|
|
|
 |
|
|
|
Feature:
- High performance,low prices
- Provides 8 kinds of microstep selection
- Special control circuit,which make the performance steady and less noise.
- Upmost response frequence amounts to 200Kpps
- Once the pulse stops for 100ms,phase current automatically cut by half.
- Bipolar constant current chopper control
- photocoupler isolated input/output
- Drive current from 1.0A/phase to 3.0A/phase
- Single power input,voltage range from DC12-48V
- Protection circuit
- ----Overheat prortection
- ----Overcurrent,under voltage protection
- Small Size
- 2D34MG is an economic compact driver,its dimension is only 118*62*30(cm ),Net weight is 0.2kg.
2D34MG Microstep Seeting 2D34MG Current Setting
 
Terminal Assignment
Diver Connection
Caution:
1. Do not reverse the power input, input voltage should not exceed DC48V.
2. Input logic should be 5V, otherwise it should connect a resistor.
3. Once over current (short circuit)/under voltage occur, LED O.C lights, please shut off power and check the electricity circuit to solve the problem, then restore power supply.
4. PWR is power indicator, it lights when power on.
|
|
Download Manual
|
| [Back] |
|
|
